TromboneChat

Any suggestions?

I have a Shires 1.5 in my 16m

Andrew

TheBoneRanger wrote: ↑Sun Nov 14, 2021 3:42 pm I have a Shires 1.5 in my 16m

Andrew

Concerns re: .508 v. .509”? A thousandth of an inch isn’t very much.

Bach5G wrote: ↑Sun Nov 14, 2021 4:18 pm

TheBoneRanger wrote: ↑Sun Nov 14, 2021 3:42 pm I have a Shires 1.5 in my 16m

Andrew

Concerns re: .508 v. .509”? A thousandth of an inch isn’t very much.

Should make no difference at all.

Bach5G wrote: ↑Sun Nov 14, 2021 4:18 pm Concerns re: .508 v. .509”? A thousandth of an inch isn’t very much.

None - any manufacturer sends them out marginally undersized (within 2 or 3 thou, hopefully, but I've seen much smaller) so that they get in and out smoothly, esp on horns where the pipe has been pulled and maybe not every last trace of solder has been cleaned out. If you/your tech later decide to v slightly expand the end for a closer fit, that's easily done.

As the person who bought your 32H pipe, I can say that I still prefer my Kanstul H8. (The 32H isn't bad at all, though - just heads in a different direction )

Depends what you want from it. It sounds most like a 16M with the original pipe, super flexible but quirky up top in both response and intonation, H8 is generally a bigger sound, somewhat more open but with more predictable high slotting, potentially sloppy if you get lazy, 32H much more focused and with a much narrower/controlled articulation. YMMV, &c.

Bach5G wrote: ↑Sun Nov 14, 2021 4:18 pm

TheBoneRanger wrote: ↑Sun Nov 14, 2021 3:42 pm I have a Shires 1.5 in my 16m

Andrew

Concerns re: .508 v. .509”? A thousandth of an inch isn’t very much.

Once a little gunk builds up, you won't notice a difference

Seriously though, I didn't even give it a thought.

Andrew

It looks like I can get a new Bach pipe for about $40 or so. The slide is about 40 years old and the mpc no longer seats without a wobble. I’ve got a few wraps of Teflon tape around the shank of the mpc at present but am thinking about replacing the lead pipe.