Page 1 of 1
Edwards Bell --> Getzen 3062 Custom
Posted: Fri Nov 15, 2019 9:14 pm
by tromboninator4000
If I wanted to put Edwards bell on my Getzen how would I go about doing so? I noticed that the braces don't exactly line up but the screw fittings are the same.
Re: Edwards Bell --> Getzen 3062 Custom
Posted: Fri Nov 15, 2019 9:24 pm
by braymond21
You'd have to get the braces moved to line up properly. A repair tech can do it for you.
Re: Edwards Bell --> Getzen 3062 Custom
Posted: Sat Nov 16, 2019 9:19 am
by GBP
When I had a 3062, I had the mounting on the bell moved. It cost about $100.00. 20 years ago.
Re: Edwards Bell --> Getzen 3062 Custom
Posted: Sun Nov 17, 2019 1:05 pm
by jjenkins
Yeah, not a difficult job. It gives you more options and increases resale value. I did it on my own to a Getzen bass I owned while in grad school. Good luck!
Re: Edwards Bell --> Getzen 3062 Custom
Posted: Sat Feb 08, 2020 12:51 pm
by HRMBTrombone
Edwards did this from the factory for a friend of mine, all he did was call and tell him the Edwards bell he wanted and asked them to move the mounts so it could fit his getzen.