Page 2 of 2
Re: Ab in 1st position
Posted: Fri Oct 25, 2024 10:58 am
by tbdana
Ouch! I think I sprained an eyeball!
Re: Ab in 1st position
Posted: Fri Oct 25, 2024 12:07 pm
by LeTromboniste
tbdana wrote: ↑Fri Oct 25, 2024 10:58 am
Ouch! I think I sprained an eyeball!
I warned ya
LeTromboniste wrote: ↑Fri Oct 25, 2024 12:21 am
We're getting way off the topic of this discussion, and I have a feeling Dana will roll her eyes so far that they'll actually still face forward
Re: Ab in 1st position
Posted: Sun Oct 27, 2024 5:59 am
by imsevimse
I just discovered I can play Ab in tune in first position on one trombone, my Gerdt TIS 216 Bb/G .500 tenor. When I ordered that horn I asked Lars to make possible to tune the slide real sharp. This means if I make the horn as short as possible and check with a tuner my Ab in first is in tune. My tuner is set to a=442, because this is how orchestras tune here. It works in a=442 but should work even better with a=440. In 442 I need to bend the note a bit (pinch it) so the sound isn't as open, I suppose if I play in 440 it would work better. Of course then I need to play even longer positions than I normally do. Backside is if I tune this way I do not know if my arms will be long enough for a B on seventh. With a trombone with a valve I think this would not be a problem.
/Tom
Re: Ab in 1st position
Posted: Sun Oct 27, 2024 1:42 pm
by Posaunus
imsevimse wrote: ↑Sun Oct 27, 2024 5:59 am
I just discovered I can play Ab in tune in first position on one trombone, my Gerdt TIS 216 Bb/G .500 tenor. When I ordered that horn I asked Lars to make possible to tune the slide real sharp.
/Tom
If only I could afford to have a special trombone made to play a single note!
I'll have to try this on my Conn trombones with spring slide bumpers. But they are - a large-bore tenor and a single-valve bass. Unlikely to need to play a first position high Ab!