I have two old 2Bs from the early 40s. Been reading old posts here and the general wisdom is they used epoxy type lacquer making them a bear to strip. The question is, do we know when they started using epoxy or is that all they ever used.
Would like to have one of these stripped and restored like new or...
King Lacquer
-
Bluesfish
- Posts: 5
- Joined: Wed Jul 10, 2019 6:02 pm
-
tbonesullivan
- Posts: 1617
- Joined: Tue Jul 02, 2019 9:06 am
- Location: New Jersey
- Contact:
Re: King Lacquer
The early 40s would be way too early for epoxy lacquer. At that time it would probably be solvent based lacquer, which is easily removable.
The "King Lacquer" everyone refers to is the 60s-70s orange/yellow lacquer that they used on bell sections for a while. I do not know if it was epoxy though, as I have heard it isn't that hard to remove, and you can use citristrip.
The "King Lacquer" everyone refers to is the 60s-70s orange/yellow lacquer that they used on bell sections for a while. I do not know if it was epoxy though, as I have heard it isn't that hard to remove, and you can use citristrip.
David S. - daveyboy37 from TTF
Bach 39, LT36B, 42BOF & 42T, King 2103 / 3b, Kanstul 1570CR & 1588CR, Yamaha YBL-612 RII, YBL-822G & YBL-830, Sterling 1056GHS Euphonium,
Livingston Symphony Orchestra NJ - Trombone
Bach 39, LT36B, 42BOF & 42T, King 2103 / 3b, Kanstul 1570CR & 1588CR, Yamaha YBL-612 RII, YBL-822G & YBL-830, Sterling 1056GHS Euphonium,
Livingston Symphony Orchestra NJ - Trombone
-
bigbandbone
- Posts: 589
- Joined: Thu Jan 17, 2019 7:45 am
Re: King Lacquer
Many years ago when I ran the brass department in a high volume repair shop I had a hot lye tank just to strip King horns that were in for overhaul. It used to leave a lot of scale on the brass, but it was the only thing that would strip King lacquer.
-
Bluesfish
- Posts: 5
- Joined: Wed Jul 10, 2019 6:02 pm
Re: King Lacquer
DB37,
Thanks, I too thought it to be too early for epoxy finishes.
BBB,
So in your experience pretty much all Kings were tougher than other brands to strip? Just curious at this point.
Thanks, I too thought it to be too early for epoxy finishes.
BBB,
So in your experience pretty much all Kings were tougher than other brands to strip? Just curious at this point.