MV Bach slide compability

SwissTbone · Post by **SwissTbone** » Thu Mar 07, 2019 11:27 am

Does a modern Bach 42 slide fit a MV 42 bell section?

Post by **Matt K** » Thu Mar 07, 2019 11:51 am

The short of it is that they are nominally the same part, so they *should*, but there is no guarantee it will fit.

elmsandr · Post by **elmsandr** » Thu Mar 07, 2019 7:08 pm

As mentioned in the other thread, I have a lot of old Bachs. Currently I have a NY 50 and 45; Mt. V 42, 45; and Elkhart 42 and 50. Slides from 1940's-1990's. They are all interchangeable. Not even a 'well, kinda.' They all are perfectly interchangeable.

I wouldn't be too surprised to learn that a taper or a receiver was worn out, but I would expect them to fit just fine.

Cheers,
Andy

ExZacLee · Post by **ExZacLee** » Sun Mar 10, 2019 4:15 pm

Should fit... if it's a bit loose due to wear, a little piece of paper should be enough to tighten it.

Bach5G · Post by **Bach5G** » Sun Mar 10, 2019 7:09 pm

A bit of plumbers tape work?

LIBrassCo · Post by **LIBrassCo** » Wed Mar 13, 2019 5:47 am

Fwiw, I did have a case of a bronx era bach 50 not fitting a modern era slide. Actually, it did fit, just the thread pitch was different. This could be an isolated example, however.

MV Bach slide compability

MV Bach slide compability

Re: MV Bach slide compability

Re: MV Bach slide compability

Re: MV Bach slide compability

Re: MV Bach slide compability

Re: MV Bach slide compability